FITRE TWIN S, Руководство пользователя

Страница: 3 / 8

TWIN S
Order information
Type glass hood
colour
P/N
TWIN S clear
TWIN S red 7332952
TWIN S yellow 7332951
TWIN S green
TWIN S blue
• Optical and acoustic telephone signalling device
• Protection category IP 66
• 4 different signalling tones
• Sound pressure approx. 95 dB(A) at 1 m
Operation
The weatherproof, optical and acoustic signalling device TWINKombi has been designed for use in general industrial
areas and allows for both indoor and outdoor operation.
Since 2002 the TWIN-Kombi can be connected to and operated with analogue telephone systems or any device with a
dry contact. In order
to ensure compatibility of the TWIN-Kombi with previous TWIN models, upon delivery the operation mode has been set
to connection with analogue telephone systems.
Note
Please read the User's Guide care - fully prior to installation of the device.
Any damage or claims are subject to the latest version of the "All - gemeine Lieferbedingungen für Erzeugnisse und
Leistungen der Elektroindustrie" (“General Terms of Delivery for Products and Services of the Electric Industry”).
Mounting
The TWIN-Kombi may be wallmounted. Make sure to mount the device in order to prevent dust and water from gathering
in the horn. This device must be installed at a height
≥ 2,5 m above the ground.
The fasteners and the mounting surface must be able to withstand the weight of the device (~0.9 kg).
Connecting and setting the operation mode
Only qualified technicians may connect and adjust the device.
Connecting:
Unscrew the flashlight hood from the base. The tensile strength reducer between the parts allows the flashlight hood to
hang freely. Insert the wires into the terminal room through the cable glands (fig. 1) and connect them according to the
marking.
Prevent damage to the wire from the hot parts of the connection by keeping the wiring short and direct.
Now you may change the settings - read more about this below.
Replace the lid, make sure the seal is clean and in good condition, and pull in the 2 screws slightly. Then tighten the
screws firmly until the lid is pressed against the base. Make sure the cable glands are securely fastened to the housing
and the cable. Follow the rules and regulations for connecting electrical devices to the 230 V power system.
When assembling the device, please pay attention to the "UP" ("OBEN") notes in the flashlight hood and the base. Both
notes must face in the same direction to ensure the device is assembled correctly.
Remove the information (depending on the version) supplied from inside the device, in order to avoid a possible fire
hazard.
Service
You have bought a modern product subject to strict quality control.
If any questions or malfunctions should occur – even after the guarantee has expired – please contact your FITRE
partner. Please have the product number (to be found on the nameplate) ready.