August 10, 2005
2
Lit. No. 13648/9511, Rev. 07
SAFETY INFORMATION
NOTE: Maintain proper belt tension for correct belt
functioning.
NOTE: Lubricate grease fittings after each use.
Use good quality multi-purpose grease.
NOTE: Airborne noise emission during use is
below 70 dB(A) for the spreader operator.
Torque Chart
Recommended Fastener Torque
Chart (Ft.-Lb.)
Size
SAE
Grade 2
SAE
Grade 5
SAE
Grade 8
1/4-20
5/16-18
3/8-16
3/8-24
7/16-14
1/2-13
9/16-12
5/8-11
3/4-10
7/8-9
1-8
6
11
19
24
30
45
66
93
150
150
220
9
18
31
46
50
75
110
150
250
378
583
13
28
46
68
75
115
165
225
370
591
893
Metric Grade 8.8 (Ft.-Lb.)
Size
Torque
Size
Torque
M 6
M 8
M 10
M 12
M 14
M 16
7
17
35
60
95
155
These torque values apply to fasteners
except those noted in the instruction.
CAUTION
Read instructions before assembling.
Fasteners should be finger tight until
instructed to tighten according to torque chart.
Use standard methods and practices when
attaching spreader including proper personal
protective safety equipment.
CAUTION
Disconnect electric power at spreader
electrical wiring harness connection and tag
out if required before servicing or performing
maintenance.
CAUTION
Do not leave unused material in hopper.
Material can freeze or solidify, causing unit to
not work properly. Empty and clean hopper
after each use.
CAUTION
If rear directional, CHMSL light or brake
stoplights are obstructed by the spreader, the
lights shall be relocated, or auxiliary directional
or brake stoplights shall be installed.
CAUTION
• Do not operate a spreader in need of
maintenance.
• Before operating the spreader, reassemble
any parts or hardware removed for cleaning
or adjusting.
• Before operating the spreader, remove
materials such as cleaning rags, brushes,
and hand tools from the spreader.
• Before operating the spreader, read the
owner's manual.
• While operating the spreader, use auxiliary
warning lights, except when prohibited by
law.
• Tighten all fasteners according to the Torque
Chart. Refer to Torque Chart for the
recommended torque values.
