Lit. No. 76454/76455/76456, Rev. 02
14
July 15, 2018
OPERATING THE SPREADER – CAB CONTROL
STARTING AND STOPPING MOTOR
1. To start the spreader, press the
POWER switch to the "ON" position on the control.
2. Press the POWER switch to the "OFF" position
to stop the spreader. Speed of auger and spinner
may be adjusted separately to get desired
fl
ow
and spread distance.
NOTE: The UTV ignition must be ON to start the
spreader.
NOTE: If UTV ignition is turned OFF while
spreader is running, the motor will stop.
Vibrate
ON/OFF
Switch
Spinner Speed
Dial
Power ON/OFF
Switch
Auger
Speed Dial
ADJUSTING AUGER/SPINNER SPEED
1. Turn the speed dial clockwise to increase
speed. When the POWER switch is set to the
"ON" position, the spreader will accelerate to the
speed set on spinner and auger dials.
2. Turning the speed dial counterclockwise will
decrease speed.
NOTE: Always use the tarp kit on the hopper to
prevent moisture buildup. Do not let spreader sit
idle with material in the hopper for an extended
period of time. This can cause material to
compact, reduce or stop the
fl
ow of material, and
cause permanent hopper body deformation.
NOTE: The vibrator switch is needed for dense
material or to increase the
fl
ow to the auger. This
eliminates bridging of material in hopper.
NOTE: A material baf
fl
e has been installed in your
spreader to stop
fi
ne material from free
fl
owing.
If using dense or damp material, or if more
fl
ow
is desired, remove material baf
fl
e. However, it is
recommended that the material baf
fl
e remain in
place if using bulk salt.
WARNING
Never operate equipment when under the
in
fl
uence of alcohol, drugs, or medications
that might alter your judgment and/or reaction
time.
WARNING
Never allow children to operate or climb on
equipment.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
