Lit. No. 94196/94197/94198, Rev. 05
12
November 1, 2010
NOTE: Periodically throughout the snow and
ice control season, verify mounting devices are
secure.
1. Remove the chute from the inside of the hopper:
a. Unlatch the rubber straps located at the rear
of the lids near the handles.
b. Remove the screens.
c. Remove the screen supports.
d. Remove the chute and replace the screen
supports and screens.
e. Close the lids and latch the rubber straps.
2. Remove the tailgate from the truck.
3. Attach the truck mounting bars to the sill brackets:
a. Measure the width between the wheel wells.
b. If needed, cut one or both of the supplied bars
to the correct length.
c. Attach them to the sill brackets using the
supplied hardware as shown.
MOUNTING THE SPREADER
4. The spreader can be moved into the truck bed
either by lifting the spreader by the four molded-in
handles located on the corner legs or by sliding
the spreader into the truck bed from the ground.
5. To lift the spreader into the truck bed from the
ground, stand the spreader up on the feet at the
rear of the spreader on top of two spacers at least
2" off the ground. The chute must be removed.
6. Position spreader on its feet at the rear of the
truck.
CAUTION
Before lifting, verify hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
Rubber
Straps
Spacers
Molded-In Handles
(Both Sides)
Attach Truck
Mounting Bars
Bottom of
Spreader
