Lit. No. 95026, Rev. 01
6
March 15, 2018
7197‑1
5.
Using four 1/2" x 1‑1/2" cap screws and
1/2" locknuts, loosely fasten a thrust arm to the
outside of both mounts, connecting the stabilizer
brackets and the rear mount holes.
Thrust arms are interchangeable and can
install on either side of the vehicle. There is no
left or right side‑specific part.
Be sure to insert the cap screws through the
stabilizer brackets pointing inward from outside the
vehicle to ensure access to the M10 cap screws
for later tightening.
6.
Install the cross bar with the horizontal leg on the
bottom using four 1/2" x 1‑1/2" cap screws and
1/2" locknuts as shown below. Keep fasteners
loose for now.
Cross Bar
1/2" x 1-1/2" Cap Screws
1/2" Locknuts
Rear Mount Holes
4.
Lower the stabilizer bar by removing the two cap
screws located on the bottom of the frame rail on
each side of the vehicle.
Position a stabilizer bracket between the bottom
of the frame rail and the stabilizer bar retainer for
both sides, facing inward as shown below.
Loosely fasten with the M10 cap screws provided.
NOTE: Thread provided M10 cap screws into
the underside vehicle frame weld nuts. Cross
threading will strip these nuts or fail nut weld.
Cap Screws
Vehicle Frame Hole
Stabilizer Bracket
Stabilizer Bar
Passenger's Side
