Lit. No. 95026, Rev. 01
5
March 15, 2018
7197‑1
3.
Remove the nuts from the bumper fastener
assembly on both sides of the vehicle. For both
driver‑side and passenger‑side mounts, align
the forward mount holes with the protruding
cap screws and guide the mounts onto their
respective fastener assembly. Loosely fasten by
reinstalling the original nuts.
If the vehicle was equipped with compatibility
brackets, reinstall one of the original bracket
cap screws through the rear hole of each mount
and the existing hole in the vehicle frame. Secure
with the original nut.
INSTALLATION INSTRUCTIONS
NOTE: For easier assembly and installation,
vehicle and all snowplow components should
be on a smooth, level, hard surface, such as
concrete.
1.
Remove the lower plastic portion of the bumper.
Save all parts for reinstallation.
Vehicles equipped with tow hooks will need the
tow hooks and outer tow hook brackets removed.
These cannot be reinstalled with the snowplow
mount in place. Retain the tow hooks, brackets,
and fasteners for reinstallation if the mount is
removed. The inner tow hook brackets can remain
in place.
2.
Remove the compatibility brackets from the frame,
if so equipped (see illustration below). Save the
brackets and hardware for the vehicle owner.
Compatibility
Bracket
Fastener
Assemblies
Compatibility Bracket
Cap Screw
Outer Tow Hook Bracket
