7
Setup and Use
To prevent serious injury or death:
•
Fall Hazard
- Never use on any elevated
surface, since child’s movement may cause
product to slide or tip over. Use only on
a floor.
•
Suffocation Hazard
- Never use on a soft
surface (bed, sofa, cushion) since product
can tip over and cause suffocation in
soft surfaces.
Always use restraint system.
•
Never leave child unattended.
•
Do not use product once child can
•
sit unaided.
This product is not intended to replace
•
a cot or bed for prolonged periods of sleep.
Never use toy bar to carry product.
•
Never use as a carrier or lift while child
•
is seated.
WARNING
1
Restraint Belts
Securing Your Infant
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the restraint belts to the restraint pad.
Make sure you hear
a “click” on both sides
.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
Restraint Pad
2
• Tighten each waist belt so that the restraint system is snug against
your child. Please refer to the next section for instructions to
tighten the waist belts.
Restraint System
3
To tighten the restraint belts:
• Feed the anchored end of the restraint belt up through the buckle
to form a loop
A
. Pull the free end of the restraint belt
B
.
To loosen the restraint belts:
• Feed the free end of the restraint belt up through the buckle to
form a loop
A
. Enlarge the loop by pulling on the end of the loop
toward the buckle. Pull the anchored end of the restraint belt to
shorten the free end of the restraint belt
B
.
Anchored End
Anchored End
TIGHTEN
LOOSEN
Free End
Free End
