TM
Note:
You may want to install the Power Wheels
®
6 volt
batteries before assembling the seat. Please see “Battery
Installation” on page 24 for detailed instructions.
• Fit the tab on the front of the seat into the slot near the
gas tank.
• Push down firmly near the back of the seat to snap it to
the vehicle.
Hint:
You will need to remove the seat to access the
high speed connector and to charge the 6 volt batteries.
To remove the seat, press the tab at the back of the seat
and lift.
Slot
Tab
Tab
Seat
Gas
Tank
36
Assembly
PUSH
HERE
20
TM
• Insert a #8 x
3
/
4
" screw through the hole in each side of
the gas tank and into the vehicle frame.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Gas Tank
Vehicle
Frame
35
TM
• Balance the sound box on the vehicle body.
(The speaker should face down.)
• Fit the tabs at the bottom of the gas tank under the front
end of the vehicle body.
• Lower the gas tank on the vehicle frame, making sure
that the two small square openings in the gas tank fit
over the buttons on the sound box.
Buttons
Tabs
Vehicle Body
Gas Tank
Vehicle
Frame
Sound Box
34
Hint:
To replace the batteries in the sound box, simply
remove the screws from the gas tank and remove the gas
tank from the vehicle frame. After replacing the batteries,
be sure to replace the sound box, gas tank and screws.
73218pr-0920.qrk 5/21/01 2:29 PM Page 20
