• Turn the frame upright.
• Insert the fork post up through the hole in
the frame neck.
Make sure the fork is
positioned so that the fork covers face
the rear wheels.
• Place the electronic handlebar over the fork
post and push it down onto
the frame. Make sure the
handlebar is positioned so
that the screw hole faces
the rear wheels and aligns
with the screw hole in the
fork post.
• Insert the #8 x 4" screw
through the hole in the
handlebar and into the fork
post so that part of the
screw (about
3
/
4
") is still
visible. Tighten the screw.
Electronic
Handlebar
Frame Neck
Fork Covers
Fork
Post
Assembly
Assembly
6
6
• Slide a pedal on the pedal axle. Tap the pedal with a
hammer until it is secure.
• Pull the pedal up to be sure it is secure. If you can
remove it, you have not secured it properly. Tap it with
the hammer again.
• Repeat this procedure to attach the other pedal to the
other end of the pedal axle.
9
Pedal
Pedal Axle
Front Wheel
Assembly
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #10 x
3
/
4
" screws into the fork cover and tighten.
• Repeat this procedure to attach the other fork cover to the
other fork arm, using the #10 x
3
/
4
" screws.
10
Fork Cover
Fork Arms
Groove
Pedal Axle
Scrap Block
of Wood
11
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052, U.S.A.
©2003 Mattel, Inc. All Rights Reserved.
® and
TM
designate U.S. trademarks of Mattel, Inc.
Printed in Mexico
B2488pr-0920
3/
4
"
FIRST, insert the screw
so that
3
/
4
"
is visible.
THEN, tighten the screw.
B2488 RRR Trike Deluxe 4/17/03 2:07 PM Page 6
