• Face the front end of the vehicle body.
• Slide a washer onto one of the
front axles.
• Slide a round bushing, ring end first, onto the front axle.
• Slide a wheel (ribbed side first) onto the front axle.
• Slide a hubcap (indented side out) onto the front axle.
• Fit a .437 cap nut on the end of the front axle.
• Fit the cupped end of the cap nut assembly tool over
the cap nut and tap the end of the cap nut assembly
tool with a hammer to secure the cap nut on the end of
the axle.
• Repeat this procedure to assemble a washer, round
bushing, wheel, hubcap and cap nut to the other
front axle.
Wheel
Round
Bushing
Washer
Hubcap
Cap Nut
Assembly
Tool
Cap Nut
Assembly
TM
• Press the tab under the back of the
seat and lift to remove the seat.
• Make sure the motor harness wires are positioned in
the channel to prevent them from being pinched
between the cowling and vehicle body.
• Fit the rectangular opening in the cowling over the
shifter handle.
• Align the front, side and rear tabs on the cowling with
the slots in the vehicle body but do not snap the tabs
into the slots.
TM
Cowling
Shifter
Handle
Side
Tab
Side
Tab
Rear Tab
PRESS HERE
To Snap Front Tabs
• Press firmly on the front of the cowling to snap the four
front tabs into the slots in the vehicle body. Make sure
the side and rear tabs stay aligned with the slots.
Note: Pull up on the front of the vehicle body while
pressing down on the cowling to make sure the front
tabs snap into the slots.
11
7
8
9
PULL UP HERE
To Snap Front Tabs
Ring
End
Round Bushing
Motor
Harness
