FISHER HAMILTON SAFEAIRE series, Руководство по установке, Страница: 10 / 32

10
Dimensions are nominal and illustrations and specifications are based
on the latest product information available at the time of publication.
The right is reserved to make changes at any time without notice.
SAFEAIRE
®
LABORATORY FUME HOODS
OPERATION, MAINTENANCE AND INSTALLATION INSTRUCTIONS
INSTALLATION
HOPEC IV FUME HOOD INSTALLATION
1. Install and level two fume hood base cabinets with rear
fillers and kneespace panel as required.
2. Depending on height requirements, install either the top filler
frame assembly alone or in combination with the optional-
height filler frame.
HOPEC IV Hood
Base
Cabinet
Trough
Assembly
Run silicone
sealant bead
on back flange of
trough. Place work
surface into frame
and onto trough
flange.
If the TOP FILLER FRAME ONLY IS
REQUIRED, insert rough assembly into top
filler frame and locate front lower edge of
trough flush with cabinet or optional height
filler. Secure to the base cabinet using
eight (8) No. 10 X 5/8" PPHSMS through
the side returns of the Top Filler Frame into
the front and rear returns of the base
cabinet.
If the OPTIONAL HEIGHT FILLER FRAME
IS REQUIRED, it is installed by aligning
it’s bottom 3/4" return on the base
cabinet and securing with (4) No. 10 X
5/8" PPHSMS screws. Insert through
assembly into Top Filler Frame and locate
front lower edge of trough flush with
cabinet or optional height filler. Attach the
Top Filler Frame to the Optional Filler
Frame using eight (8) No. 10 X 5/8"
PPHSMS through the side returns of the
Top Filler Frame into the front and rear
returns of the base cabinet.
36"
Work Surface
Height
Top Filler Frame
Optional Filler
Filler
End view showing HOPEC IV hood,
Top Filler Frame and Base Cabinet.
Optional
Height Filler
Top Filler
Frame
Work
Surface
Base
Cabinet
HOPEC IV Hood
Base
Cabinet
36"
Work Surface
Height
Top Filler Frame
Filler
End view showing HOPEC IV hood,
Top Filler Frame, Optional Height
Filler and Base Cabinet.
Trough
Assembly
Run silicone
sealant bead
on back flange of
trough. Place work
surface into frame
and onto trough
flange.
Lower front
edge of trough
should be flush
with front of
cabinet
Top Filler
Frame
Work
Surface
Base
Cabinet