Fisher & Paykel WL26CW1, Руководство по дополнительному обслуживанию

Страница: 8 / 41

517794B
8
1.6 Wash Motor
Electronically commutated 36 pole direct drive 3 Phase brushless DC Motor.
Motor Resistance per Phase 16
Ω +/- 10% @ 68
o
F (20
o
C).
1.7 Pump Motor
The motor is a fully electronically controlled 325V, 3 phase, 6 pole, brushless DC motor.
The speed of the motor will vary depending on whether it is draining or recirculating the water.
Motor Resistance per Phase: 8.1
Ω +/- 10% (16.2 Ω +/- 10% across any two phases).
Maximum Wattage: 200W
Nominal Wattage: 60W
Drain Speed: 2500rpm
Recirculation Speed: 2000 rpm
Head Height Drain Speed Flow Rate
4ft (Nominal) 2500rpm 6.2 gallons (23.6 litres) per minute
8ft (Maximum) 2500rpm 3.9 gallons (15 litres) per minute
1.8 Water Valves
Supply Mode of
Operation
Voltage Resistance Flow Rate
Cold Digitally Operated 24V DC 64 Ω @ 68
o
F (20
o
C) 2.6 Gal (10 litres) per min.
max
Hot Digitally Operated 24VDC 64 Ω @ 68
o
F (20
o
C) 2.6 Gal (10 litres) per min.
max
Detergent Digitally Operated 24VDC 64 Ω @ 68
o
F (20
o
C) 2.1 Gal (8 litres) per min.
max
Fabric Digitally Operated 24VDC 64 Ω @ 68
o
F (20
o
C) .5 Gal (2 litres) per min. max
Note: Flow rate will vary slightly depending on pressure.
Water Supply
•
For best operating conditions your hot water should be approximately 149 ˚ F. The hot water
should not exceed 167 ˚ F or the cold water exceed 95 ˚ F. Temperatures above these may
cause the machine to fault or cause damage to the machine.
•
If there is an uncontrolled water-heating source (eg a wet back or solar heating) a tempering
device should be fitted. This will ensure the hot water temperature remains within safe limits.
For the most suitable type of tempering device we recommend a local plumber or plumbing
supply merchant be contacted.
•
Inlet Water Static Pressure 3psi (20kPa) to 150psi (1MPa).
Note: If using a header tank, then the top of the header tank must be at least 2 metres above
the top of the clothes washer.
•
Minimum flow rate from the tap supplying the clothes washer should be greater than 1.6
gallons (6 litres) per minute (assumes ½ inch diameter pipes).
•
Minimum height of taps to clear the top of the machine is 45.25 inches (1150mm).
1.9 Thermistor
NTC-type temperature sensor (Thermistor) Resistance 10,000 Ω @ 77
o
F (25
o
C)
1.10 Cabinet
Pre-painted steel
1.11 Lid
ABS plastic (co-injected)