INSTALLATION
2A
CORRECT
INCORRECT
1. Connect the straight ends of the white inlet hoses
to the taps. There are washers fitted in both ends.
2. Connect the elbow ends of the white inlet hoses to
the machine inlet valves. Inlet valves are marked
on the back of the machine
H=Hot
C=Cold.
Cold supply only:
If you only have a cold water supply, an inlet valve cap
(blanking cap) MUST be connected to the hot inlet
valve. The cap prevents water leaking out of the hot
valve. The cap is available from your Fisher & Paykel
Dealer or Authorised Service Centre, Part No. 388491.
This appliance incorporates backflow protection
complying with AS3500.1. No further backflow
protection is required for connection to the water supply.
It is IMPORTANT to level the machine to ensure even
spin performance.
1. Separate the 4 rubber foot inserts from the moulding
and fit into the feet on the base of the machine.
2. Move the machine to its final position. (We
suggest a minimum clearance of 20mm each side).
3. Adjust the feet so the machine is level and cannot
rock.
To check if your machine is level:
Look down on the wash bowl and make sure it sits
slightly forward of centre (see diagram).
Close the lid. Visually check that the lid fits evenly on
both sides.
If it does not look like the diagram in the middle,
adjust one of the front feet slightly until it matches.
The diagram on the left and right are not correct.
4. Turn on the water and check all hose connections
for leaks. Make sure there are no kinks in the hoses.
5. Uncoil power cord and plug into wall socket.
TAP END
MACHINE END
INLET HOSES
ADJUSTABLE FEET
RUBBER INSERT
LEVELLING
To check levelling look
down on the wash bowl
2408 SmartDrive U&C.qk 15/3/02 09:38 Page 36
