When the range is not being used, set the gas dials to their OFF positions. If the range will
not be used for an extended period of time, it is recommended that the gas shut off valve in
the main supply line be closed.
Lighting Gas Burners fitted with Flame Failure
Safety Device (Triple-Ring and Semi-Rapid
Burners)
In order to light the burner, you must:
1. Push and turn the dial in an counter-clockwise direction to
the
HI
position (maximum rate), push in and hold the dial
until the flame has been lit (fig. 2.2).
The sparks produced by the electrode situated inside the
relative burner will light the flame.
In the event that the local gas supply conditions makes it
difficult to light the burner in
HI
position (maximum rate), try
again with the dial in
LO
position (minimum rate).
2. Wait for about ten seconds after the gas burner has been lit
before letting go the dial (safety device activation delay).
3. Adjust the gas valve to the desired position.
If there is no mains electrical supply, the burners can be used with
no restriction. In that case, in order to light the burner, you must:
1. Bring a lighted match close to the burner (as per side figure)
and keep it in place until the burner has been ignited.
2. Push and turn the dial in an counter-clockwise direction up to
the
HI
position (maxi- mum rate), push in and hold the dial
until the flame has been lit (fig. 2.2).
In the event that the local gas supply conditions makes it
difficult to light the burner in
HI
position (maximum rate), try
again with the dial in
LO
position (minimum rate).
3. Wait for about ten seconds after the gas burner has been lit
before letting go the dial (safety device activation delay).
4. Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.
To re-light the burner, return the dial to the closed
OFF
position, wait for at least 1 minute and then repeat the lighting
Updated: Thu, 11 Nov 2021 19:59:30 GMT
Powered by
3