Fisher & Paykel ELBA CG604 Series, Инструкции по установке и Руководство пользователя

Страница: 15 / 32

13
INSTALLATION INSTRUCTIONS
Adjusting the minimum burner setting
●
This has been adjusted at the factory for Natural Gas but may need adjusting for local
conditions.
●
When converting to LPG, the minimum setting MUST be re-adjusted for each burner.
●
To adjust the minimum setting, you will need a Ø 3 X 75mm screwdriver.
1 Light the burner and set the control dial to its minimum.
2 Remove the dial and the plastic cover over the valve.
3 Slowly turn the adjustment screw on the valve until a minimum regular flame is
achieved. Note:
●
The flame will diminish when the screw is turned clockwise, and increase when turned
anti-clockwise.
4 Refit the plastic cover and dial.
5 Check the minimum burner setting: quickly turn the dial from maximum to minimum.
The flame must not go out. If it does, repeat the steps above.
Repeat the steps above for each burner.
Adjusting the minimum burner setting