32
8.9 Removing the Drain Pump
8.10 Removing the Wash Pump & Heater Assembly
•
Remove the product from the joinery.
•
Remove the base panel from the machine, and
disconnect the flood switch assembly.
•
Remove the wiring harness to the drain pump.
•
Depress the clip and rotate the drain pump
anticlockwise to release.
•
When reassembling the drain pump, ensure the
lock clip engages to secure the pump.
•
Disconnect and remove the product from the
joinery.
•
Remove the screws securing the base panel from
the machine, and disconnect the flood switch
assembly and remove base panel completely.
•
Sometimes laying the product on it’s back is
the easiest option to service, however ensure no
hoses are damaged and the floor is covered to
stop any possible damage.
•
Remove the wiring harness and earth wires to
the wash pump and element assembly.
•
Remove the hose clamps securing the supply
hose from the sump and supply hose to the
spray arms.
•
Pull the hoses off the sump fittings.
•
The wash pump is hung from 2 rubber
grommets. To release the wash pump slide the
pump backwards to release.
rubber
grommets
slide
backwards
The FC6 model uses a different wash pump, but the
same principle is used to service.
8 SERVICING THE COMPONENTS
D
D
D
