23
6 DIAGNOSTICS
Menu L:
Turn the power on at the On/Off
button, so the wash display is showing but do not start a cycle.
Press and hold the On/Off
button and the Start/Pause
button simultaneously for 5 seconds.
To get to menu (L), press the Program Selector button, the display will show the letter L in the
display, to enter the menu press the Start/Pause
button.
In this menu the following will happen:
•
All indicators inside the user interface will be illuminated
•
A buzzer will sound
•
The error code memory will be cleared/reset
•
The wash cycle repeat mode flag will be cleared/reset
Menu P:
Turn the power on at the On/Off
button, so the wash display is showing but do not start a cycle.
Press and hold the On/Off
button and the Start/Pause
button simultaneously for 5 seconds.
To get to menu (P), press the Program Selector button, the display will show the letter P in the
display, to enter the menu press the Start/Pause
button.
This is the factory wash test cycle, when entered the product will do the following:
•
Display 16 (min) on the display
•
Fill with water (4.5L)
•
Wash and heat
•
Drain wash water
•
Turn off
Menu C:
Turn the power on at the On/Off
button, so the wash display is showing but do not start a cycle.
Press and hold the On/Off
button and the Start/Pause
button simultaneously for 5 seconds.
To get to menu (C), press the Program Selector button, the display will show the letter C in the
display, to enter the menu press the Start/Pause
button.
The display will show 3, and in this menu the product will automatically calibrate the turbidity sensor.
Start the calibration by pushing the Start/Pause
button. The wash icon will illuminate and the
product will calibrate the turbidity sensor.
It does this by checking the fresh fill water against the pre programmed setting in the contoller.
Menu S:
Turn the power on at the On/Off
button, so the wash display is showing but do not start a cycle.
Press and hold the On/Off
button and the Start/Pause
button simultaneously for 5 seconds
To get to menu (S), press the Program Selector button 4 times, the display will show the letter S in
the display, to enter the menu press the Start/Pause
button.
Note:
The show room mode survives a power off, so will need to be manually turned off in the display to
enable correct operation of the dishwasher.
Once in menu S, press the Delay Start
button to turn the show room mode on, 51 will show in the
display. To turn the show room mode off, press the Delay Start
button again, and 50 will show in the
display
C1, 2 & 4 models
C6 model
Once in menu S, press the Wash Modifier Selection button to turn the show room mode on, 51 will
show in the display. To turn the show room mode off, press the Wash Modifier Selection button again,
and 50 will show in the display.
