Fisher & Paykel DE60F60NW1, Инструкция по установке и руководство пользователя

Страница: 15 / 20

13
Maintenance and cleaning
Water tank
The moisture in the damp laundry is taken from the clothing and condensed. Drain the water
tank after each drying cycle or during drying when the
tANk FUll
warning LED comes on.
Important!
ƒ
Condensed water is not drinkable!
ƒ
Never remove the water tank when the programme is running!
The water tank is located inside the drawer on the panel. If you forget to drain the water tank,
your machine will stop during the cycle when the water tank is full and the
tANk FUll
warning
LED will light up. If this is the case, press the
StARt/PAUSe/CANCel
button to resume the drying
cycle after draining the water tank.
To drain the water tank, carefully remove the water tank by pulling the drawer.
Fig.9 Emptying the water tank
1 Drain the water by opening the water tank cover.
2 If there is lint accumulation in the water tank cover, clean it and press to close.
3
Place the water tank back into its seat.
Condenser
Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the
humid air circulating in your machine is condensed and then pumped into the tank.
ƒ
Clean the condenser after every 20 drying cycles or once a month.
To clean the condenser
ƒ
If a drying process has been carried out, open the door of the machine and wait until it cools down.
1
Open the kick plate, unlock the four condenser locks, and pull out the condenser.
2
Clean the condenser with pressurised water and wait until the water drains.
3
Replace the condenser with the side labelled “Top” facing upwards.
4
Lock the four condenser locks. Make sure that the red lock on the upper right corner is
engaged securely.
5
Close the kick plate cover.
Fig.10 Cleaning the condenser