Fisher & Paykel DE4560M, Инструкция по установке/Руководство пользователя

Страница: 14 / 40

INSTALLATION INSTRUCTIONS
12
Wall mounting
1
Determine the position of the dryer on the wall and mark the bracket
position. A minimum of 50mm is needed between the top of the dryer
and the ceiling for ease of installation. If mounting above a washing machine,
allow sufficient room to open the lid of the washer.
Refer to page 11 for lid clearances.
From c
entr
e
of t
op hole
From bott
om
of dry
er
C
B
835mm
555mm
A
555mm
2
Fix the wall hanging brackets to
the wall securely, ie into the stud.
If the studs are too far apart, fit
a timber slat to the studs and
then mount the brackets to the
slat. If a slat is used, install a
second slat behind the spacers
to ensure the dryer is horizontal.
The distance between the centre
of each bracket is 555mm (
A
).
3
To install the hooks onto the
dryer, remove one screw from
each side (
B
), reuse these
screws with two more (each side)
from the kit to fasten the hooks
in place.
4
Remove plastic plugs from the
back of the dryer and screw the
spacers provided in place (
C
).
5
With assistance, mount the dryer
on the wall brackets.
6
Fit inverted control panel over
the existing panel.
7
Adjust the display to read
correctly on an inverted panel:
z
For DE7060M, DE6060M
and DE5060M press and
for three seconds.
z
For DE4560M press and
for three seconds.
z
The dryer will beep to indicate
you have made a correct
selection, and the display will
change after three seconds.
z
Repeat the same steps
to return the panel to the
factory setting.