INSTALLATION INSTRUCTIONS
13
Before a rear venting option is installed the dryer must be changed from the front
venting factory setup. Remove the outlet grille from the front left-hand side and replace
with the outlet cover from the rear left-hand side. These covers should be gently pried
at the sides to prevent damage.
External venting options
z
Kits are available that allow the dryer to be vented
upwards or to the side.
z
The dryer can be vented directly through the wall with
a kit, in combination with the duct adaptor supplied
with the dryer.
Note: the vent system should be less than two metres
long with no more than three 90⁰ bends.
Internal venting
Front venting is the only option for internal venting.
The dryer is set up for front venting when it leaves
the factory.
Note: where possible all efforts should be made to
vent the dryer externally to avoid moisture build up
around the dryer.
Electrical connection
1
This appliance must be connected to a
220V – 240V, 50Hz, sinusoidal, 10A electrical supply.
2
Uncoil the power cord, remove and discard the plastic
pin cover and plug into a power socket.
3
Connect the appliance to an earthed outlet protected
by a fuse of suitable capacity.
z
Check the power cord for damage and make sure it is
not squashed or twisted when installing the dryer.
z
Always remove the power cord from the power socket
by the plug, not by the cord.
External venting with kit part
number PD-DK4W
External venting with kit part
number PD-SVHCW4
Содержание DE4560M
Страница 2: ......
