31
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
WHAT TO DO
The ‘Dry’ dryness
level was chosen
but load is still
damp.
Load consists of a mixture
of heavy and light fabrics.
When combining heavy and light
fabrics in a load, choose a higher
dryness level.
Lint filter, condenser, and/
or air intake vent located
on the front of the dryer is
blocked.
Inspect and clean lint filter,
condenser, and/or air intake vent
located on the front of the dryer.
Dryness sensors are dirty.
Clean the sensors with a moist cloth.
These are the metal ribs located in
the drum behind the lint filter.
Control buttons
not responding.
Controls accidentally put in
service mode.
Press
.
Controls accidentally put in
‘Keylock’ mode.
Hold the button for 3 seconds to
unlock the dryer.
Controls performed an
incorrect operation.
Check the building’s fuse/circuit
breaker box and replace fuse or
reset breaker. Note: electric dryers
use two fuses or breakers.
Dryer doesn’t
start.
Control panel is “asleep”.
This is normal. Press ‘POWER’ to
activate the control panel.
Dryer is unplugged.
Make sure the dryer plug is pushed
completely into the outlet.
Fuse is blown/circuit
breaker is tripped.
Check the building’s fuse/circuit
breaker box and replace fuse or
reset breaker. Note: electric dryers
use two fuses or breakers.
Dryer was accidentally
paused when starting ‘Delay
Start’.
If the light on the button is
flashing, the dryer is paused. Press
to restart the countdown.
Water tank is full.
If the ‘Water Tank’ light is on, you
must empty the water tank before
the dryer will start. Refer to the
‘Caring for your dryer’ section
for instructions on emptying the
water tank.
EN
