Fisher & Paykel AD55 Series, Руководство по обслуживанию, Страница: 6 / 28

- 5 -
OUTSIDE WALL MOUNTING INFORMATION
When mounting dryer on an outside wall, use the following diagrams to determine position of
mounting breaking and vent hole.
NOTE: Read these instructions in conjunction with venting instructions.
PARTS SUPPLIED
QTY DESCRIPTION PART NO
1 WALL MOUNTING BRACKET 460913
2 SPACERS 460912
2 SCREWS No 8 x 20 611944
1 INVERTED CONTROL PANEL
TOOLS AND PARTS REQUIRED
(Wooden Wall) TOOLS REQUIRED
(Concrete wall)
1 Drill and 3mm bit 1 6 mm bit
1 Phillips screw driver 2 M6 x 50 expanding bolts
2 Wood screws 14 x 50 timbertite screws. (wooded wall) 1 Adjustable spanner
1 Wood screw driver
1 Helper to lift dryer onto bracket.
PROCEDURE
1. Determine dryer position on wall and mark required bracket position
Note: If you are venting dryer through the mounting wall ensure resulting hole clears studs.
2. Fit bracket to wall ensuring fixing engagement to studs for wooded walls using wooded slat if required.
Note: fit dummy slat to wall for spacers if a mounting slat is used.
3. Fit spacers with long screws provided.
4. Mount dryer on bracket. Tilt out from below, engage bracket in back panel slots then lower and reset
against wall. You will need help to do this.