Fisher & Paykel AD55 Series, Руководство по обслуживанию, Страница: 12 / 28

- 11 -
ED55/56 OPERATING INSTRUCTIONS
The electronic dryer can sense when the
clothes are dry, taking the guesswork out of
choosing drying times. When the dryer
senses that the clothes are at the level of
dryness selected, it will automatically finish
the Drying Cycle. The dryer will run for a
minimum of 5 minutes. This allows the dryer
cabinet and drum to heat up to a stable
temperature. During which time the dryness
sensing temperatures are ignored.
The cycle times for the ED 55 and ED56
dryer on the regular setting are a minimum of
5 minutes to a maximum of 150 minutes.
Whilst on the ED56 dryer on the low setting
the cycle times are from a minimum of 5
minutes to a maximum of 250 minutes.
These are the maximum times the dryer will
run for if the load is too large, too wet or the
lint filter is blocked.
After the Drying Cycle a ten minute Cool
Down or Airing cycle commences. During the
Airing Cycle the drum tumbles, blowing cool
air through the clothes to help prevent
creasing. At the end of the Airing Cycle the
Dryer will beep for 15 seconds to tell you that
the clothes are ready.
Start 5 minutes minimum
Drying Cycle
Reverses every
8 minutes
150 max ED55/56
Reg. Cycle
250 max for ED56
low temp cycle
Airing
Cycle
10 minutes
Crease
Guard
(option) ED56 only
12 hours
- reverses
every 5 minutes
Power Supply & Connection -
The ED55/56 is designed for 230V ac 50Hz
operation. When the dryer is connected to a
power outlet, power is always supplied to the
Control. The ON/OFF switch on the ED55/56
simply tells the control to switch the LEDS off
and wait, in a standby mode, for the next
command. The ON/OFF button does not
isolate the dryer from the mains supply.
The ED55/56 Dryer can either be left
connected to the mains supply or switched off
at the wall socket or unplugged after each
use. However, if the dryer is disconnected
from the power the dryness setting in the
memory will be lost. When the dryer is
switched on again it will return to the mid
dryness setting.
Using the Electronic Dryer –
•
Plug cord into wall socket and switch on.
•
Load garments into Dryer (see Loading)
•
Clean lint filter
•
Press POWER button to turn Dryer on.
•
Select Dryness level.
•
Select Temperature setting (ED56 Dryer
only)
•
Press START/PAUSE button to start the
Dryer.
•
Try to remove the garments from the
dryer as soon as the cycle is completed, or
use the crease guard option (ED56 Dryer
only). This will prevent creasing.
Dryness Levels –
The ED55/56 have five Dryness levels
indicated by the LED’s on the control panel.
These LED’s DO NOT indicate time
intervals, but indicate a degree of dryness
the clothes will reach before the ED55/56
Dryer will switch off.
The ED55/56 will switch off when the
required dryness level is reached. The time
required to reach the selected dryness will
depend on the size of the load, how wet the
load is to start with, the types of fabrics, how