Fisher & Paykel AD55 Series, Руководство по обслуживанию, Страница: 27 / 28

- 26 -
READING DISPLAYED TEMPERATURE
The temperature is displayed using the binary
code on 8 LED’s on the control panel, i.e.
from 1 hr through to Crease Guard.
Each LED represents a certain temperature.
For each LED that is turned on it’s
corresponding temperature is added together
to give a total. This total is the temperature
(in degrees C) that the sensor is reading.
The temperatures corresponding to each
LED is as follows:
Example One
After selecting the temperature measurement
mode the following is displayed:
Add the temperatures corresponding to each
LED which is on
1 + 2 + 8 = 11
Hence the temperature is 11 degrees C.
Example Two
After selecting the temperature-measuring
mode the following is displayed:
Add the temperatures corresponding to each
LED which is on
0.5 + 2 + 4 + 8 + 16 =30.5
Hence the temperature is 30.5 degrees C
NOTE: In the temperature reading mode, the
temperatures are updated approximately
every ½ second.
The final drying temperature of the previous
drying cycle will remain latched in memory
until the START/PAUSE of the next drying
cycle is pressed. This applies to the ED56
only.