Fisher & Paykel 93275, Инструкция по установке/Руководство пользователя

Страница: 17 / 82

13
INSTALLATION INSTRUCTIONS
Before a rear venting option is installed the dryer must be changed from the
front venting factory setup. Remove the outlet grille from the front left-hand side
and replace with the outlet cover from the rear left-hand side. These covers should
be gently pried at the sides to prevent damage.
External venting options
z
The dryer can be vented with a kit that can
be positioned to vent upwards or to the side.
Kit part number PD-DK4W.
z
The dryer can be vented directly through the wall
with Kit part number PD-SVHCW4, in combination
with the duct adaptor supplied with the dryer.
Note: the vent system should be a maximum of 2 metres
with no more than three 90⁰ bends.
Internal venting
Front venting is the only option for internal venting.
The dryer is set up for front venting when it leaves
the factory.
Note: all efforts should be made to vent the dryer
externally, if possible, to avoid moisture build up in
the area around the dryer.
Electrical connection
1
This appliance must be connected to a 220V – 240V, 50Hz,
sinusoidal, 10A electrical supply.
2
Uncoil the power cord, remove and discard the plastic pin
cover and plug into a power socket.
3
Connect the appliance to an earthed outlet protected
by a fuse of suitable capacity.
z
Check the power cord for damage and make sure it is not
squashed or twisted when installing the dryer.
z
Always remove the power cord from the power socket by the plug, not by the cord.
Through-wall
mounted ducting
Wall mounting ducting