5
(6)
Shaker Output
Jack/Speakon 1+/1-
Connection for the bass shaker or the ButtKicker LFE. Max. RMS output
power 65W with Low Power , and 250W in High Power mode; minimum
output impedance 4 ohms. In High Power mode, only use the Speakon
connection because of the strain on the plug-in system. The package
The package including the ButtKicker LFE comes with a suitable
Speakon cable.
(7)
Power Selector Switch Amplifier Switch over the amplifier to High Power / Low Power mode to operate
the bass shaker Bass Pump 3 (65 Watt) or the ButtKicker LFE (250 W).
The green LED lights in position Low Power, the red LED lights in
position High Power mode. The switch is pre-adjusted to the type of
bass shaker which is supplied in the package. Due to safety reasons,
switch-over is made by means of a pointed object.
(8)
Mains Voltage Selector:
Adjustment of the mains voltage to the existing power grid 230 V AC or
115 V AC (50/60Hz).
The selector switch may only be activated when the power plug is
disconnected from the mains. The suitable mains fuse in the input
voltage socket has to be inserted: with 230V 1.25AT fuse, with 115V
insert the 2.5A fuse. Corresponding fuses are enclosed with the Drum In
Ear Amp 2.
(9)
Mains Power Switch:
Switch on the voltage supply of the unit. When switched on, the Switch
lights red.
(10)
Mains Power Input:
Euro mains socket with fuse holder to connect the mains cable.
Operating voltage 115/230VAC, 50/60Hz.
Caution: Connect a 3-pole cord with protective earth conductor (PE). Do not use any damaged
power cables.
Mounting the bass shaker to the drummer throne (for pictures see page 7):
•
Unscrew the two butterfly nuts at the mount of the bass shaker.
•
Fasten the bass shaker at the beam of the seat by means of the fastening clamp.
•
Take care for a tight fit, as otherwise the vibrations cannot be transmitted optimally.
Mounting the amplifier to the Hi-hat machine or to the rack of the drum set:
•
Attach the amplifier with the fastening clamp at an appropriate location.
•
Slightly unscrew the butterfly nut to be able to fasten the amplifier.
•
Fix the amplifier in an appropriate position with the butterfly nut.
•
Connect the bass shaker to the amplifier:
•
Plug the 6.3 mm (1/4“) jack connector or the Speakon connector of the cable which is mounted to the
bass shaker into the Shaker Output socket at the amplifier (interlock Speakon plug after inserting by
turning it in the socket).
