FISBA READYBeam, Техническая инструкция

Страница: 11 / 16

11
· Connect the USB plug to your laptop and the RS485 plug to the laser module
interface cable
· Connect the power supply to the interface cable
· Connect the interface cable to the laser module connector
· Start the READYBeam software
· Now it is possible to control the lasers via the software
2.2.5 Software interface
1. Set Modulation Mode: choose «Digital»
2. Set Power Value 1 (red), Power Value 2 (green) and Power Value 3 (blue):
values in % of the max. laser power
3. Switch the Laser on/off with Digital Enable 1, 2 or 3
4. Enter the command with « Write Config » Button
The READYBeam software is provided for download at
fisba.com/readybeam-software
2.2.6 Analog controlled operation
· Connect the power supply and signals according the pin configuration on
Table 1, page 12
· Connect the Interface cable at READYBeam
· Switch ON +12/+24V Power