First Light C-RED 2, Быстрый старт

Страница: 9 / 14

11. OPERATIONAL ENVIRONMENT
Maximum cooling fluid temperature: 35°C
Minimum cooling fluid temperature: Dew point of the room (recommended)
Maximum Use / Storage temperature: 45°C
Minimum Use / Storage temperature: 10°C
Maximum Relative Humidity: 0% to 80%*
*If the camera uses liquid cooling, be careful to the dew point
Absolute pressure: 500 mbar* to 2 bar
* First Light Imaging recommends using liquid cooling for pressure lower than 1 bar
Dew point:
Please use the cooling fluid at a temperature above the dew point. If the dew point is unknown, use a cooling
fluid at a temperature which is not below the room temperature.
12. OPERATION
By default, the camera operates in CDS mode. It can also operate in IMRO mode.
The camera can operate in full frame or in cropping mode.
Integration/readout function
The acquisition speed can be set to any value from 0.001 to 600 fps.
The integration time can also be set. The integration time range is [50µs - ~1/fps] *
*For integration time below 50µs, please contact First Light Imaging at support@first-light.fr
Sensibility scale mode
Signal can be integrated in low, medium or high gain corresponding to high, medium and small integration
capacity, respectively. The modification of the integration capacity impacts the dynamic of the signal and thus
implies a change of the noise level.
Bias/Flat Correction
Bias/Flat correction can be done on the fly by the camera.
Flat and Bias correction files can be computed automatically by the camera Alternatively, custom correction
files can be uploaded to the camera using serial connection (either USB or CL).
To apply the image corrections: First, build the bias file and apply it, then, build the flat file and apply it.
Please refer to the software demo user manual for further details.