First Degree Fitness Pacific Challenge AR, Руководство пользователя

Страница: 22 / 23

22
Fault Probable Cause Solution
Water changes color
or becomes cloudy. Rower is in direct sun-
light or has not had wa-
ter treatment. Change rower location to re-
duce direct exposure to sun-
light. Add water treatment or
change tank water as directed
in the water treatment section of
this manual.
Rower belt slipping off
belt/ bungee pulley. Bungee not under
enough tension. Tighten bungee cord following
the instructions in "Replacing
the Bungee/Shock Cord" sec-
tion of this manual.
Front of rower lifts
slightly during vigor-
ous rowing. M10X150mm Vertical
Seat Rail Tensioning
Bolt is slightly too loose. Tighten bolt 1/2 turn and row
again. Tighten as needed until
problem stops. Note: Over tight-
ening this bolt can damage the
seat rail. Only tighten bolt in
small increments until fault is
corrected.
The Pacific Challenge
AR computer does
not illuminate after
battery installation. Batteries installed incor-
rectly or need replacing. Reinstall batteries in correct po-
sition and try again. If the LCD
screen fails to illuminate, try ro-
tating the batteries slightly in the
computer. If this fails, contact
your local service center.
Pacific Challenge AR
Computer screen illu-
minates, but does not
register when rowing. Loose or failed connec-
tion. Check that the computer lead is
connected properly. If it is con-
nected then contact your local
service center.
Troubleshooting