Remote Phone Control Operation
To remotely disarm system: + [1]
To remotely arm in AWAY mode: + [2]
To remotely arm in STAY mode: + [3]
To remotely arm in AWAY or STAY with NO DELAY: + [2] or [3] + [0]
To remotely activate X10 devices 1-6: [#] + [4] + device no.
To remotely activate X10 devices 7 & 8: + [#] + [4] + device no.
To remotely deactivate X10 devices 1-6: [#] + [7] + device no.
To remotely deactivate X10 devices 7 & 8: + [#] + [7] + device no.
To remotely bypass a zone: + [6] + zone no.
To remotely activate forced bypass: + [6] + [#]
Note:
Force bypass option must be enabled.
To remotely check system status: [*]
To end remote phone session: Hang up or + [9]
Speaker Phone Operation
(Note: The ARMED and READY LEDs blink alternately when the Speaker Phone feature is active)
To place a call or answer a call using the speaker phone: [#] + AUX
To Flash (switch between two calls using call waiting): AUX
To hang up and exit speaker phone mode: OFF
To enable/disable (toggle) ringer: [#] + VOLUME + AUX
To return the keypad to telephone mode after disarming the system: [#] + AUX
Note:
The Babysitter Code and Installer Code cannot disarm the system unless it was the code used to arm the system.
In addition, if the system is armed by pressing and holding the Quick-Arm buttons, neither the Babysitter Code nor
the Installer Code can disarm the system.
REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE LIMITATIONS OF THIS SYSTEM AND
WARRANTY INFORMATION.
- 7 -
