Keypad Functions
(when default programming is used)
Security Functions
Checking system status:
STATUS (high level messages); press STATUS again for secondary messages.
To arm in STAY mode: Press and hold down STAY (or enter your code + STAY ) See note below.
To restart exit delay: STAY (applies only if system is armed in Stay mode and Quick Exit option has been enabled)
To arm in AWAY mode: Press and hold down AWAY (or enter your code + AWAY ) See note below.
To arm with NO DELAY: Press and hold down AWAY or STAY + NO DELAY or enter your user code + the keys shown).
To disarm the system and silence alarms: User Code + OFF See note below.
To bypass a zone(s): User Code + BYPASS + 2-digit zone number(s)
To turn Chime mode on or off: FUNCTION + CHIME
Message Center
To record a message: FUNCTION + RECORD
To stop recording before end of 20 seconds: OFF
To play back a message: FUNCTION + PLAY
To skip a message: [
✻
]
To delete all messages: FUNCTION + DELETE (during message replay)
Volume Control
To adjust message playback/system announcement volume: FUNCTION + VOLUME + [3] (Up) or [6] (Down)
To mute system announcements: FUNCTION + VOLUME + OFF
To restore/unmute announcements & volume: FUNCTION + VOLUME + [3] or [6]
Note:
If the system was muted during Field Programming it will be unmuted upon exiting.
Other Functions
To set the time and date: User Code + FUNCTION + [63]
To activate or deactivate X10 devices 1-6: FUNCTION + LIGHTS ON or LIGHTS OFF + device number
To activate or deactivate X10 devices 7 & 8: User Code + [#] + LIGHTS ON or LIGHTS OFF + dev. no.
To program scheduled events: User Code + FUNCTION + [64], then follow procedure in User Manual.
To add a User Code: Master Code + CODE + user User’s Code (see note below)
To delete a User Code (except Master Code): Master Code + CODE + user number
To turn Test mode on: User Code + TEST
To turn Test mode off: User Code + OFF
To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) + User Code
(To define the AUX function, refer to the procedure in the Aux Function section of the User Manual. Note: The 1-button
paging feature [field *87] is not enabled with the default programming)
To program Follow Me announcement telephone number: User Code + FUNCTION + [65]
- 6 -
