English
Page 31
Customer Service: 1-844-FIRMAN1
3. Carefully remove the carbon deposits from
the spark arrester screen with a wire brush.
Failure to clean the spark arrester will result in
degraded engine performance.
GENERATOR MAINTENANCE
Make certain that the generator is kept clean
and stored properly. Only operate the unit on
a flat, level surface in a clean, dry operating
environment.
DO NOT
expose the unit to
extreme conditions, excessive dust, dirt,
moisture or corrosive vapours.
DO NOT
use a garden hose to clean the generator.
Water can enter the generator through the cooling
slots and damage the generator windings.
Use a damp cloth to clean exterior surfaces of
the generator.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and
debris from the generator.
Inspect all air vents and cooling slots to ensure
that they are clean and unobstructed.
CAUTION
CAUTION
4. Replace the spark arrester if it is damaged.
5. Position the spark arrester in the muffler and
attach with the screws.
Spark arrester
screen
Flange
Screw
Battery Replacement
1. Remove the spark plug wire from spark plug.
2. Remove the nut and bolt from the negative(-)
and po) posts.
3. Loosen and remove the screw A on the battery
holding bracket.
4. Remove the battery and recycle and dispose
of properly.
12V sealed lead acid 15AH
LXWXH:180X75X165mm(7.09X2.95X6.5inch)
6. Connect the red po) battery cable to
the battery first.
7. Connect the black positive(-) battery cable
to the battery second.
8. Cover the post with boots.
9. Install the spark plug wire onto spark plug.
5. Install the new battery with follwoing specification:
A(M6)
WARNING
ALWAYS
connect the positive (+) battery cable
(red boot) first when connecting battery cables.
ALWAYS
disconnect the negative (-) battery
cable (black boot) first when disconnecting
battery cables.
NEVER
connect the negative (-) battery cable
(black boot) to the positive (+) post on the
battery.
NEVER
connect the positive (+) battery cable
(red boot) to the negative (-) post on the battery.
NEVER
touch both battery posts simultaneously.
NEVER
place a metal tool across both battery
posts.
ALWAYS
use insulated or nonconducting tools
when installing the battery.
To avoid electric shock: