Firman P06701, Руководство оператора

Страница: 19 / 72

Page 17
Connecting Electrical Loads
1.Let engine stabilize and warm up for a few
minutes after starting.
2.Ensure circuit breaker on control panel is in
on position.
3.Plug in and turn on the desired 120 or 240 Volt
AC, single phase, 60Hz electrical loads. It is
better to attach the item with largest load first.
Stopping the Engine
1. Turn off and remove entire electrical loads.
Never start or stop the generator with
electrical devices plugged in or turned on.
This unit has been pretested and adjusted to
handle its full capacity. Before starting the
generator, disconnect all load. Apply load only
after generator is running. Voltage is regulated
via the engine speed adjusted at the factory for
correct output. Readjusting will void warranty.
When applying a load, do not exceed the maximum
wattage rating of the generator when using one or
more receptacles. Also, do not exceed the amperage
rating of any one receptacle.
Do not apply heavy electrical load during break-in
period (the first five hours of operations).
WARNING
Let the generator run at no-load for two
minutes to stabilize internal temperatures
of the engine and generator.
If a cover is used, do not install until unit has cooled.
Fuel and its vapors are extremely flammable and
explosive which could cause burns, fire or
explosion resulting in death or serious injury.
2. Press the engine switch to the “
OFF
”(
O
) position.
3. Turn the fuel valve to the “ OFF ”( O ) position.
Do not leave the generator until it has
completely stopped.
English Customer Service: 1-844-FIRMAN1
NOTICE
DO NOT stop engine by moving choke control
to “
START ” position.
NOTICE Always ensure that the
is in the “ OFF ” position when the engine
is not in use.
fuel selector
switch