3
FIGURE 1.
DIMENSIONS OF DIN RAILS, WIRING BASES AND FLAME SWITCH MODULES SHOWN IN INCHES (MM)
CERTIFICATION:
The MBCE-230UV-1 & MBCE-230UV-3 have been evaluated to EN 298:2012 by DIN DVGW, and
meet the Gas Appliance Directive (2009/142/EC)
CE Certificate # CE-0085CR0115
DIN DVGW Certificate # NG-4131CR0016
DIN CERTCO Certificate # 5F249
1.4
1
1.38
1.06
.2
DIN RAIL MOUNT
60-2539-12
60-2539-24
60-2539-36
L = 12" (305)
L = 24" (610)
L = 36" (914)
PART NO.
LENGTH
L
(35)
.3
(7.5)
(25)
(36)
(5)
(27)
DIMENSIONS IN INCHES (MM)
(50.8mm)
(76.2mm)
(101.6mm)
.13
DIA. TYP.
3.18
2.96 75.06
.14 3.56
1.46 37.08
1.49 37.82
1.03 26.09
2
1
6
11
10
10
5
7
8
9
3
4
STYLE: 11 pin octal, snap-mount/surface mount
TYPE OF CONNECTION: Screw connection
STRIPPING LENGTH: 10mm
SCREW THREAD: M3
WIRE SIZE: Maximum up to 2 - #14AWG each terminal
ELECTRICAL RATING: 400V, 10A
To secure MBCE-110/230UV to socket use retaining kit P/N 60-2886
NOTICE:
The MBCE-UV is designed to be used with a compatible UV scanner in order to sense
the flame activity in a combustion chamber. The MBCE-UV is not designed to replace a burner
control system, and it cannot assume the responsibilities of a burner control system, including
burner safe start check.
NOTICE:
Consult national or local codes for proper selection of the MBCE-UV modules. Some
codes require that the flame failure detection time should not be greater than 1 second.
WARNING:
The equipment described in this manual is capable of causing property damage, severe
injury, or death. It is the responsibility of the owner or operator to ensure that the equipment is
installed, operated and commissioned in compliance with the requirements of all national and local
legislation, which may prevail.
Installation, commissioning or adjustment of this product MUST be carried out by suitably trained
engineer or personnel qualified by training or experience.
