www.desatech.com
114745-01D
4
Keep the appliance area clear
and free from combustible ma-
terials, gasoline and other flam-
mable vapors and liquids.
Solid fuels shall not be burned in
a fireplace in which an unvented
room heater installed.
Children and adults should be
alerted to the hazard of high tem-
perature and should stay away to
avoid burns or clothing ignition.
1. This appliance, as supplied, is only for use
with the type of gas indicated on the rating
plate. This appliance is not convertible for
use with other gases.
2. Do not place propane/LP supply tank(s) in
-
side the structure.Locate propane/LP supply
tank(s) outdoors (propane/LP units only).
3. If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do not use
any phone in your building
• immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions
• if you cannot reach your gas supplier, call
the fire department
4. This heater shall not be installed in a bedroom
or bathroom, unless installed as a vented
appliance. See
Installing Damper Clamp Ac-
cessory for Vented Operation
, page 12. This
gas log set may not be installed as a vented
appliance in a bedroom or bathroom in the
Commonwealth of Massachusetts.
5. Before installing in a solid fuel burning fireplace,
the chimney flue and firebox must be cleaned of
soot, creosote, ashes and loose paint by a qualified
chimney cleaner. Creosote will ignite if highly
heated. Inspect chimney flue for damage. If dam
-
aged, repair flue before operating appliance.
6. If fireplace has glass doors, never operate with
glass doors closed, If you operate heater with
doors closed, heat buildup inside fireplace will
cause glass to burst. Also if fireplace opening
has vents at the bottom, you must open the
vents before operating heater.
SAFETy INFORMATION
Continued
7. To prevent the creation of soot, follow the instruc
-
tions in
Cleaning and Maintenance
, page 20.
8. Before using furniture polish, wax, carpet
cleaner or similar products, turn heater off. If
heated, the vapors from these products may
create a white powder residue within the burner
box or on adjacent walls and furniture.
9. This heater needs fresh, outside air ventilation
to run properly this heater has an Oxygen De
-
pletion Sensing (ODS) safety shutoff system.
The ODS shuts down the heater if enough fresh
air is not available. See
Air Combustion and
Ventilation
page 6. If the heater keeps shutting
off, see
Troubleshooting
, page 22.
10. Do not run heater
• where flammable liquids or vapors are used
or stored
• under dusty conditions
11. Do not use heater to cook food or burn paper
or other objects.
12. Do not use heater if any part has been exposed
to or under water. Immediately call a qualified
service technician to inspect the room heater
and to replace any part of the control system and
any gas control which has been under water.
13. Do not operate heater if any log is broken. Do
not operate heater if a log is chipped (dime-
size or larger).
14. Turn heater off and let cool before servicing,
installing or repairing. Make sure the selector
switch is in the OFF position. Only a quali
-
fied service person should install, service or
repair heater.
15. Make sure the selector switch is in the OFF
position when you are away from home for
long periods of time.
16. Remote-ready heaters shall not be connected
to any external electrical source.
17. Operating heater above elevations of 4,500
feet may cause pilot outage.
18. To prevent performance problems, do not use
propane/LP tank(s) of less than 100 lb. capac
-
ity (propane/LP units only).
19. Provide adequate clearances around air
openings.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
