Firepower TIG 200 AC/DC, Руководство по эксплуатации

Страница: 50 / 80

FIREPOWER TIG 200 AC/DC INSTALLATION
3-22 Manual 0-5370
Installation
3.15 SETUP FOR STICK (SMAW) WELDING
A. Connect the Electrode Holder lead to the positive welding terminal (+). If in doubt, consult the electrode
manufacturer. Welding current flows from the Power Source via heavy duty bayonet type terminals. It is
essential, however, that the male plug is inserted fully and turned clockwise until tight to achieve a sound
electrical connection.
B. Connect the work lead to the negative welding terminal (-). If in doubt, consult the electrode manufacturer.
Welding current flows from the power source via heavy duty bayonet type terminals. It is essential, however,
that the male plug is inserted fully and turned clockwise until tight to achieve a sound electrical connection.
C. Select STICK mode with the process selection control (refer to Section 3.08.7 for further information)
!
WARNING
Before connecting the work clamp to the work and inserting the electrode in the electrode holder
make sure the mains power supply is switched off.
CAUTION
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in
the bayonet terminal.
8
Positive Welding
Terminal (+)
Electrode Holder
Work Lead
A-12721
200A
Negative Welding
Terminal (-)
Figure 3-11: Setup for Stick Welding.