Firenzo DECO RURAL SD, Инструкция по установке и эксплуатации

Страница: 18 / 22

Deco RU SD & Plaza RU SD Installation
18
6. INSERT FLUE SYSTEM
For Installation in a Masonry Fireplace
WARNING; The appliance and flue system
must be installed in accordance with AS/NZS
2918:2001 and the appropriate requirements of
the relevant building code or codes.
1. Position heater in fireplace. Extend plumb
line from top of chimney, ensuring heater spigot
is in line with top of chimney. If not, flue pipe
offsets will be required.
2. Assemble flue pipes ensuring all seams are in
line and assembly is straight and tight with
crimped ends pointing downwards.
Secure flue pipes with at least 3 stainless steel
or monel rivets and seal.
3. Fasten chimney plate supplied onto the
chimney top. The chimney plate must be
weather sealed with silicone or mortar.
4. Install chimney liner on top of the chimney
plate.
5. Ensure flue pipe is extended over the
chimney liner by 180mm. Secure top spacer
bracket to the flue pipe and ensure slots fit
snugly inside the chimney liner.
6. Slide flashing cone over top of flue, until it
rests firmly over top spacer. Ensure ventilation
gap is not closed off. Secure with pop rivets or
self tapping screws.
7. Fit anti-down draught cowl. Do not secure
as it must be removed for cleaning.
CAUTION: Mixing of flue system components from different sources or modifying the
dimensional specifications of components may result in hazardous conditions. Where such action
is considered the flue manufacturer should be consulted in the first instance.
Refer also to notes on page 19 regarding height of flue system outlet
.