REV. 8-9-19 Page 10
AWS Sanctuary 2 & 3 Fire Features
INSTALLING PAN INTO BOWL & WIRING
INSTALLING BURNER PAN INTO BOWL
After the mounting plate is secured inside the bowl,
attach a flex line to the bottom fitting of the mounting plate
and the other end to the primary gas supply.
Install the GOE-30DCV power supply and FG-1420-AOD
remote control as shown in the wiring diagram (Fig 8).
Note
: Ensure the external antenna on the FG-1420-AOD
receiver is outside the junction box.
This is a polarity sensitive system. There is a red sleeve
attached to the positive (+) side of the DC power supply.
When wiring the remote control receiver, cut off both 1/4”
terminals and strip both wire ends. Connect one red wire
from the receiver to the GOE-30DCV power supply with
the red sleeve; secure with wire nut. Connect the other red
wire from the receiver to the + (positive) directly to the red
wire from the gas valve control box; secure with wire nut.
See Fig. 8.
Note:
An extra red jumper wire is provided to extend either
one of the red wires of the FG-1420-AOD remote control
receiver (if needed). It is not required to use this wire. It
depends on each application.
DO NOT CONNECT 120VAC DIRECTLY TO THE GAS
VALVE WIRES -DAMAGE WILL OCCUR. THIS IS NOT
COVERED BY WARRANTY.
LEARN
Weather
Proof
Box
AWS
Valve Box
GFI Box
+
-
+
GOE-30VDC
Power Supply
FG-1420-AOD
Receiver
Fig.
8
Wiring diagram.
Note:
Use dielectric grease inside of all wire nut
connections to protect from the outside elements.
Plug the GOE-30VDC power supply and remote receiver
into the 120VAC GFI box. Install battery into the
transmitter of the FG-1420-AOD and “learn” (program)
the receiver to the transmitter. Ensure the slide switch on
the receiver is in the REMOTE position See Fig. 9; Press
and Release the “learn” button on the receiver. You will
hear the receiver emit a short “beep”. Once this occurs,
press any button on the transmitter and the receiver will
emit several rapid beeps confirming the two are programed
together.
ON
REMOTE
OFF
LEARN
Slide
Switch
Fig. 9
1420-AOD slide switch and learn button.
