REV. B Page 19
Round & Square Flat Disc
SECTION B THERMOCOUPLE FLAME SENSE (TFS) INST
ALLA
TION
CAUTION
: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING:
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of control system and any gas control, which has been under water.
OPERATION
SAFETY WARNINGS
1. Never leave the fire pit unattended during operation.
2. Clothing or other flammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualified service person. The appliance should be inspected before
use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause severe burns if contacted.
2. Do not burn any solid fuels in this appliance.
LIGHTING INSTRUCTIONS
NOTE
: It may take several cycles of ON/OFF to purge the airflow from the gas lines. The direct spark ignition
will turn OFF after 15 seconds. If the burner does not light, you will need to press the OFF button on the transmitter then
then ON again to initiate ignition.
Flame height is HI and LO. By pressing the buttons on the handheld transmitter you can operate ON-OFF-HI-LO. The
transmitter defaults to the HI setting when initially lighting the fire pit each time but will remember the last setting used and
change back to that last setting in approximately 5 seconds after lighting.
READ ALL WARNING AND SAFETY INFORMATION ABOVE BEFORE ATTEMPTING TO LIGHT FIRE PIT
LOW
HI
OFF
ON
TURNING OFF FIRE PIT
1. To turn OFF the fire pit, press the OFF button on the transmitter. Fire pit will turn OFF.
2. After fire pit has completely cooled off, install cover.
Fig. 23
Transmitter
TURNING ON FIRE PIT
1. Ensure you have leak tested the fire pit before operating. Turn main gas supply ON.
2. Ensure batteries are installed in battery pack and switch is on Latching Solenoid.
3. Press the
ON
button on the transmitter (Fig. 23) You will hear the ignitor probe begin
sparking for 15-seconds and the fire pit will turn ON.
4. If the fire pit does not light the module will “beep” one time every second indicating an
ignition error. This is a hard lockout. If this occurs press the
OFF
button on the remote
control and repeat step 1-3.
5. If fire pit does not light after second try, turn main gas OFF, wait 5 minutes and repeat
steps 1-3.
