4
INSTALLATION
Installation will be much easier if two ( 2 ) or more people co-
operate in locating and installing the unit.
LOCATION
This appliance, must be installed only in a solid-fuel burning
fireplace, with a working flue, and constructed of
noncombustible materials.
!!! IMPORTANT !!!
Before installing this appliance, have the fireplace and
chimney, professionally cleaned, to remove any ashes, soot,
creosote, or other obstructions. Perform this cleaning
annually, after installation.
!!! IMPORTANT !!!
Seal any fresh air vents or ash clean-out doors located on the
floor or wall of the fireplace. If this is not performed, drafting
may cause pilot outage or sooting. Use a heat-resistant
sealant; DO NOT seal the chimney flue damper.
!!! WARNING !!!
Gas supply system must be installed in accordance with the
U.S. National Fuel Gas Code.
This appliance and its individual shut off valve must be
disconnected from the gas supply piping system during any
system pressure test in excess of ½ PSI ( 3.5 KPA ).
Use a system manual shut off valve to shut off the gas supply
to this gas appliance before continuing with
installation
procedures.
FIGURE 2 – FIRE ISLAND BURNER PAN – MATCH THROW – FRONT ANGLE VIEW
FIGURE 3 – FIRE ISLAND BURNER PAN – WITH GAS CONTROL VALVE
WHEN INSTALLING THE APPLIANCE, DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
