12
LIGHTING INSTRUCTIONS
UNITS WITH SAFETY PILOT continued
LIGHTING THE BURNER SYSTEM
11- To manually light the burner system, gently press and turn
the gas control knob, in a counter-clockwise direction, to
the “ FULL ON “ position. Gas should ignite within
approximately five ( 5 ) seconds. Adjust burner flame by
opening or closing manual gas shut-off valve.
FOR UNITS WITH REMOTE SYSTEMS
See the instructions that are packaged with the remote, and/or
instructions on Page 7, of this manual.
WARNING:
If ignition does not take place,
TURN THE GAS
OFF
, at the manual shut-off valve, and wait five ( 5 ) minutes,
before attempting to relight the appliance. If after repeated
attempts, the appliance does not ignite, contact your installer,
or the
fire
gear Service Center.
PILOT FLAME ADJUSTMENT
FIGURE 25
The pilot flame should be a soft blue in color, and should
surround the last 1/2” of the thermocouple tip. The pilot
adjustment screw is located on the valve, just to the right of the
control knob. ( SEE FIGURE 22 )
If the pilot flame must be adjusted, use a standard slotted
screwdriver to turn the screw clockwise to reduce the flame, or
counter-clockwise to increase the flame.
( SEE FIGURE 22 & 25 )
MAINTENANCE & SERVICE
Your
fire
gear FIRE ISLAND HEARTH SYSTEM should be
thoroughly inspected on a regular basis, at least once a year,
by a qualified installer.
At the beginning of each heating season, the system should be
checked as follows:
1-
Check the chimney flue or vent pipe to make sure that the
flue is drawing properly, and that any vent pipe
connections are tight.
2-
Check to see that there are no blockages at the chimney
or vent termination.
3-
Check for creosote, or soot build up in chimney or vents,
and clean if necessary.
4-
Pilot and burners should be inspected annually, at the
beginning of each heating season.
ADJUSTMENTS
The burner system has been adjusted for proper operation at
the factory. No adjustment is necessary, other than altitude
de-rate, or pilot flame.
NEVER enlarge valve orifices or burner ports.
PILOT FLAME
MUST SURROUND
THERMOCOUPLE
TIP AS SHOWN
PILOT FLAME
THERMOCOUPLE
