Fired Up Corporation Adam, Инструкция по использованию и уходу

Страница: 10 / 16

1 0
SECTION 03
Mirror
Clip
Surround
(Leg)
16mm
Screw
Location
Wall
32mm screw
and wall
plug
location
INSTALLATION
This surround is floor-standing and must be fixed to a wall. Please ensure both the wall
and floor are flat before installation and that secure anchorage points can be made to
the wall. Always ensure there is enough room to place suite.
Please ensure that there is an accessible electrical socket within reach of the supply
cord. The electrical socket must not be behind or above the suite.
WARNING! Never cut off the plug and hard wire into a fixed fused spur
Before installing this product please take note that should removal or relocation of the
product be necessary, any installation methods used may be left exposed.
Note: If fitting the product to plaster board with a cavity behind then propriety wall
fixings (not supplied) will be required.
To secure the suite to the wall, follow the instructions below:
This method applies to both A and B type contemporary electric suites. Please be aware
that styles may vary
UNINSTALL
Unplug the unit and remove the two screws securing the bracket to the wall
1. Attach a mirror clip to the
back of each leg as shown using
4 x 16mm screws. Pre-drill the
holes to stop the MDF splitting.
2. Place the surround to the wall,
and mark the positions of the
exposed holes on both mirror
clips.
Note: Check the wall does not
have any wiring or pipe work
behind where you intend to drill.
3. Using an electric drill (6mm
bit), drill holes into the walls
approximately 35mm deep.
4. Insert the wall plugs, then
secure the suite with 2 x 32mm
screws (supplied).