S
.
tep 9 – Attach Reflector Assembly to Studs
.
Support Heater.
The minimum permissible gas supply pressure of
10 W.C. is required for purpose of input adjustment.
Slide 3 M 8 Flat Washers over threaded end
of
The minimum hourly of 17000 BTU is required
.
The pressure regulator and hose assembly supplied
Reflector Studs.
rating for a heater for automatic operation at ratings
less than full input rating.
.
The installation must conform with local codes, or in
3 Wing Nuts
6
M8 Flat Washers
w
ith the appliance must be used.
.
A dented, rusted or damaged propane cylinder may
the absence of local codes, with National Fuel Gas
Code, ANSI Z223.1.
be hazardous and should be checked by your cylinder
supplier. Never use a propane cylinder with a
damaged valve connection.
The propane cylinder must be constructed and
marked in accordance with the specifications for LP
.
.
Place Reflector Assembly on 3 studs.
Install M8 F lat W ashers on studs & securely tighten
.
Never connect an unregulated propane cylinder to the
wing nuts but do not over-tighten!
gas
cylinders
of
the U.S.
Department
of
Transportation (DOT).
.
heater.
Screw regulator onto gas hose. Do not cross-thread.
.
Specifications
Step 10 – Connect Hose & Regulator to Cylinder
Tighten securely.
Attach regulator to cylinder.
Complete attachment.
You must
provide
and
propane gas
propane cylinder. Use a
.
cylinder only.
standard 20 lb. propane
Use this heater only
with a propane vapor
withdrawal
supply
system. See Chapter 5
of the Standard for
Storage and Handling
of Liquefied Petroleum
Gas, ANSI/NFPA 58.
Your local library or
Install cylinder.
fire department should have this book.
7
Standard 20 lb. tank
NOT INCLUDED
