To immediately arm the system enter
[USER]
after the last zone
bypass.
FORCED ARMING
Forced Arming is a method that will automatically bypass all
zones that are not ready and ARM the system.
FORCED ARMING PROCEDURE;
BYPASS [USER] BYPASS
Depress the BYPASS key followed by your user code and the
BYPASS key.
If any of the zones currently faulted are not bypassable, then
the command will not succeed, and a long interrupted beep will
follow.
Following a sucessful forced arming the ARMED indicator will
be lit.
If you are leaving the premise, you may exit through an
exit/entry door for the duration known as the exit entry delay.
>>
Note: You have just ARMED the system and the bypassed
portions of your system re main unprotected.
UNBYPASS
The UNBYPASS function removes an existing bypass from a
currently bypassed zone. After UNBYPASSING a zone, the bypass
indication will be removed from that zone.
The procedure is similar to a bypass.
UNBYPASS PROCEDURE
11
DISARMING
Disarming the security system will deactivate the burglary
portions of the system.
DISARM PROCEDURE:
[USER]
Enter your user code.
IF NO ALARMS HAVE TAKEN PLACE
Upon disarming the ARMING indicator will go off.
The system display will reflect the current status.
IF ALARMS HAVE TAKEN PLACE
If alarms or other conditions such as system troubles have
taken place since the initial system arming, they will appear on the
display. The conditions that have occurred appear in the zone
display section of the keypad. Each indicator light reflects the
status of each zone as follows;
ALARM
Fast blinking
TROUBLE
Slow pulse
BY PASS
NOT READY
Slow low lntenslty blinking
Solid ON
If an intrusion has taken place while you were away, do not enter
until the premisis has been secured!!!.
>>
To clear the display of the alarm or trouble conditions and
silence the audible signal enter [USER] again.
BYPASS [USER] ZN See bypass description.
12
Содержание LEGEND series
Страница 1: ......
