Fiori D 70 SL, Руководство по эксплуатации и обслуживанию

Страница: 188 / 212

60 SEBU8325-01
Maintenance Section
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Periodic cleaning of the engine is recommended.
Steam cleaning the engine will remove accumulated
oil and grease. A clean engine provides the following
benefits:
• Easy detection of fluid leaks
• Maximum heat transfer characteristics
• Ease of maintenance
Note: Caution must be used in order to prevent
electrical components from being damaged by
excessive water when the engine is cleaned. When a
pressure washer or steam cleaner is used to clean
the engine, a minimum distance of 300 mm (12 inch)
must be maintained between the components of the
engine and the jet nozzle of the pressure washer
or steam cleaner. Pressure washers and steam
cleaners should not be directed at any electrical
connectors or the junction of cables into the rear of
the connectors. Avoid electrical components such as
the alternator and the starter. Protect the fuel injection
pump from fluids in order to wash the engine.
i02690459
Engine Air Cleaner Element
(Dual Element) - Clean/Replace
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements with
damaged pleats, gaskets or seals. Dirt entering the
engine causes premature wear and damage to engine
components. Air cleaner elements help to prevent air-
borne debris from entering the air inlet.
NOTICE
Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
Servicing the Air Cleaner Elements
Note: The air filter system may not have been
provided by Perkins. The procedure that follows
is for a typical air filter system. Refer to the OEM
information for the correct procedure.
If the air cleaner element becomes plugged, the air
can split the material of the air cleaner element.
Unfiltered air will drastically accelerate internal
engine wear. Refer to the OEM information for the
correct air cleaner elements for your application.
•
Check the precleaner (if equipped) and the dust
bowl daily for accumulation of dirt and debris.
Remove any dirt and debris, as needed.
• Operating in dirty conditions may require more
frequent service of the air cleaner element.
• The air cleaner element should be replaced at least
one time per year. This replacement should be
performed regardless of the number of cleanings.
Replace the dirty air cleaner elements with clean air
cleaner elements. Before installation, the air cleaner
elements should be thoroughly checked for tears
and/or holes in the filter material. Inspect the gasket
or the seal of the air cleaner element for damage.
Maintain a supply of suitable air cleaner elements
for replacement purposes.
Dual Element Air Cleaners
The dual element air cleaner contains a primary air
cleaner element and a secondary air cleaner element.
The primary air cleaner element can be used up
to six times if the element is properly cleaned and
properly inspected. The primary air cleaner element
should be replaced at least one time per year. This
replacement should be performed regardless of the
number of cleanings.
The secondary air cleaner element is not serviceable.
Refer to the OEM information for instructions in order
to replace the secondary air cleaner element.
When the engine is operating in environments that
are dusty or dirty, air cleaner elements may require
more frequent replacement.
g00736431
Illustration 25
(1) Cover
(2) Primary air cleaner element
(3) Secondary air cleaner element
(4) Air inlet
1. Remove the cover. Remove the primary air
cleaner element.