MAINTENANCE
S32B
Revision 00 Maggio 2006
Page 29 di 37
4.2
STORAGE
The machine must be stored in a closed and dry place if not immediately installed in order to keep every part
safe.
Relative humidity must be lower than 80% and the storage temperature must be between
3°C
≤
t
≤
+ 45 °C.
4.3 INSTRUCTIONS TO UNPACK THE MACHINE
¾
Cut off the bands being careful of the elastic reversion
¾
Take away on the base of the cartoon the clips that keep it together with the pallet.
¾
Where plywood is take away the clips at both sides and at the base of each panel.
¾
Cut off the clips that stop the machine.
¾
Put the machine at ground level.
4.4 HANDLE THE UNPACKED MACHINE
¾
Check the machine and mount the batteries if not installed.
¾
To displace it, after use, take off the battery cables, the brushes and the squeegee; to deplace it
through a longer space pack the machine once again in its own package.
4.5
BATTERIES INSTALLATION
To install the batteries follow the instructions as below :
¾
Raise up the battery-cover chain guard;
¾
install the batteries in the suitable slot being sure that no breakings are in the battery cases;
¾
never add distilled water after charging the batteries;
¾
clean up the surfaces needing to be connected ;
¾
Battery handling is made easier by handles on both sides.
4.6 CHARGER INSTALLATION
The battery charging must be done, as previously reminded, predisposing a suitable suction system of gases
coming out during charging. Alternatively it must be done in a dry and airy place, far from heat sources and
corrosive environments.
Protect the electrical system with a delayed switch or with a more capacity fuse than the charger.
Follow the polarity instructions for the battery inlet.
