710-0148 HM 44
Page 5 of 11
08/06/19
Rev. 01
4.
Place the left wall in slot of the floor panel and latch to the back
wall.
5.
Place the front panel in the slot of floor panel.
6.
Place the ceiling
panel on the four wall panels.
*Make sure trim of
the top panel fits completely
around the four side
panels.
*Make sure the
connection wires from the
front panel, right
wall panel, and back wall
panel protrude
through the hole of the ceiling
panel.
7.
Connect the wires in the ceiling panels accessed via flip-up panel as shown above. There are three access
doors. Back Right, Right Wall and Front Right
.
Note: Match each wire connection to the similar corresponding connector
type.
