710-0148 HM 44
Page 3 of 11
08/06/19
Rev. 01
Read Before Installation
The portable sauna unit comes with an option of two heater sizes; 1.7kW or 2.2kW.
The 1.7kw can be used on all 15 amp or 20 amp household outlets (the standard 120 volt outlet
found in all homes).
A dedicated circuit is advisable to avoid unnecessary tripping of the
breaker.
The 2.2kW unit can only be used on dedicated 120 volt, 20 amp circuit.
A
dedicated circuit is required to avoid unnecessary tripping of the
breaker.
The Sauna should be plugged into a NEMA (5-15R or 5-20R)
Amp electrical outlet.
•
Each panel is heavy. Be careful to avoid injury when installing, especially the top panel.
•
Two adults are required for the installation of sauna room.
•
There is a pin or a slot on the sides of each panel, which will be installed correspondently
with one pin to one slot in the following way when installing:
o
The panel with pin should be lifted about 1 inch (2 cm) higher than the panel with
the slot (Refer to Picture 1).
o
Place the panel with the pin against the panel with the slot (Refer to Picture 2), and
then slide the panel with the pin down until the two panels are equal in height (Refer
to Picture 3).
o
If they are not equal in height or there is an obvious gap between the two panels, that
means they are not properly attached, and you should try again.
Note:
The vents must be kept free from any obstruction so proper airflow is maintained in the
sauna room. Do not stack anything in front of the vents or push the back of the room up tight to a
wall surface.
5-15R 5-20R
