Finn HydroSeeder T90, Инструкция оператора и каталог запасных частей

Страница: 49 / 126

43
APPLICATION OF SLURRY (CONTINUED)
III. PROCEDURES WHEN USING HOSES (CONTINUED)
5. If another load is to be done, see RELOADING PROCEDURE. If finished for the day,
follow the clean up procedure described in DAILY CLEANING AND MAINTENANCE and
flush out the hose.
The recirculation valve must be open when using a remote valve.
Failure to comply will result in death or serious injury.
B. EXTENSION HOSE SYSTEM – WITHOUT REMOTE VALVE
1. Connect extension hose into end of discharge boom.
2. An operator controlling the end of the hose, directs a second operator at the machine to
control the the slurry pump clutch and adjust the engine speed.
Since the extension hose will be seeing the full output of the slurry
pump with the recirculation valve closed, the equipment operator and
individual at the end of the hose should exercise extreme care when operating unit on high
pressure. The high pressure on the hose can exert strong forces causing hose operator to
lose control of hose or footing. The hose will require additional holders on slopes. Engage
the clutch only after the hose operator is fi rmly positioned and has fi rm control of hose.
Failure to comply could result in minor or moderate personal injury. Failure to comply could
also result in product or property damage.
3. When hose operator is ready, signal the second operator to engage (turn on) the slurry
pump clutch with the engine at low idle and then slowly increase the engine rpm until the
desired discharge pressure is reached.
Do NOT engage the slurry pump clutch above 1000 RPMs or damage
to the slurry pump clutch will occur.
4. When finished spraying, disengage (turn off) the slurry pump clutch, stop the engine, and
close the discharge valve. If using fiber mulch, retain as much water as possible in the
hose by elevating the ends or by coupling the ends together.
5. If another load is to be done, see RELOADING PROCEDURE below. If finished for the
day, follow CLEANING PROCEDURE and flush out the hose.
RELOADING PROCEDURE
1. Start at step 2 in LOADING SECTION.
2. After last load of the day, refer to CLEANING AND MAINTENANCE section.