Finn HydroSeeder T90, Инструкция оператора и каталог запасных частей

Страница: 16 / 126

10
PRE-START CHECK
The following safety check should be made to ensure operator safety:
1. A. Skid Unit – Check condition of all mounting hardware that secures HydroSeeder
®
to
truck frame rails.
B. Trailer Unit – Inspect hitch, safety chains, lights, brakes, and breakaway switch.
2. Make sure bag cutter is in place and secure.
3. Inspect that all railings are in place and secure.
4. Ensure that all guards are in place.
EQUIPMENT CHECK
Equipment check should be made with the engine OFF and all
rotating parts stopped. Failure to comply could result in death or
serious injury.
1. Verify that tool kit contains all the prescribed items. See PARTS SECTION.
2. Inspect slurry tank for foreign objects. See step 3 in Section IV, MAINTENANCE of the
HYDROSEEDER
®
SAFETY SUMMARY SECTION.
3. Check fuel level. Fill if necessary.
4. Check hydraulic oil level and fill if necessary. See HYDRAULIC SYSTEM for oil
specifications.
5. Check engine oil level and fill if necessary. For oil type, refer to the engine manual.
6. Check fluid level in radiator and overflow tank.
7. Inspect air cleaner for dust and dirt, clean if necessary.
8. Secure drain plug on the outside-bottom of slurry tank.
9. Check to make sure the slurry pump drain plug is in place.
10. Verify that the suction line shut-off valve is completely open.
11. Engage (turn on) and disengage (turn off) the slurry pump clutch to determine if it snaps
in and out.
12. Install discharge assembly (if stored in location other than standard operating position).
A. Check and clear nozzle of any obstructions.
B. Tighten wing bolt at the opening around the top of discharge assembly and ensure
that discharge assembly is secure.
13. Check slurry pump discharge and recirculation valve handles for free movement.